Contact Us

Fujian Lydoo Group Co.,Ltd

Add:4F, No.280 Factory Building, Shanghu Community, Huli District, Xiamen, Fujian, China

Tel:+86-180 5922 5856


PVC sports floor installation

- Jan 02, 2018 -

PVC sports floor installation

First, the mobile installation of pvc sports flooring:

Between the floor and the floor with the manufacturers supporting the  connection with a special bonding, flooring and floor surface is not  bonded, PVC flooring can be free to roll up or move away, easy to move.

Second, the fixed installation of pvc sports flooring:

1.  Semi-fixed: special double-sided tape, between the floor and the floor  with the manufacturers supporting the special double-sided adhesive tape  bonding into one, while the floor and ground are also connected  together, can effectively prevent the floor due to strenuous exercise  occurred Move, slit, but also for the future because of the need to do the entire venue to move.
2. Local bonding: on the ground to the edge of the floor brush 20cm inward brushing.
3. Full plastic bonding: all the glue on the ground in the upcoming laying glue.
Construction of the ground grass-roots must be clean, long-lasting clean, smooth, and no cracks. Concrete surface moisture content can not exceed 2.5%. Gypsum ground moisture content shall not exceed 0.5%. Before laying the floor. Floor by dust, you can lay PVC sports flooring. If the original uneven ground can also be constructed about 2mm self-leveling. If it is non-absorbent floor such as mineral grass, stone, tiles, etc., can be directly paved.
[Note]: If it is a wet basement floor, the floor must be waterproof to isolate the water vapor.
【installation steps】:
Laying the ground must be smooth and clean.
2.PVC  sports flooring in the laying, it must be pre-tiled in the laying of  the ground for more than 24 hours, and the site temperature should not  be less than 15 ℃. Floor reduction, cut at both ends should stay 5cm. Before pasting, unfold the unrolled floor about halfway in the reverse  direction, then apply the glue - starting from the middle - the glue is  applied with a toothed scraper.
3. According to the order of the number of the floor line up, aligned  and merged, pay attention to the course pavement line alignment.
4.  Opened along the seams at the adjacent two of the floor, the  manufacturers supporting the special connecting tape on the underside of  the joint at the surface of the adhesive brush, first one of the panels  stuck half of the connection, and then Stick the other half to the rest of the connection strap, the gap can be tight.
5. It is recommended to use harmless water-soluble glue for construction. Paste the floor with cork blocks from the middle to squeeze the floor  at both ends of the surface to make it flat without bubbles, the most  complete rolling smooth.
6. After the floor to be glued after slotting, welding, welding wire shovel should be flat.

  • 24*24 Vinyl Floor Tiles
  • PVC Laminate Flooring
  • Vinyl Wood Flooring
  • Luxury Vinyl Flooring
  • Loose Lay Vinyl Flooring
  • Kids Vinyl Flooring

Related Products